The five signs
- Milky or cloudy oil. This usually means water has got in.
- Dark oil with a burnt smell. The oil has overheated or aged.
- Foam in the tank. Air is mixing in, which can come from a low level, a leak on the suction side or worn oil.
- A noisy or whining pump. Air or a restricted inlet can cause this, and it can damage the pump if ignored.
- Slow response or running hotter than usual. Sludge and wear reduce efficiency, so the machine works harder.
Check before you change
Colour alone can mislead. Oil can look dark and still be serviceable, or look fine and be contaminated. A simple oil analysis checks viscosity, water content, acidity and particle count, and tells you far more than the eye can.
If the oil keeps going bad quickly, find the cause. Check for leaks, a failed breather, a blocked cooler or a worn pump, otherwise fresh oil will degrade the same way.
Getting the most from new oil
- Drain the system while the oil is warm so more of the contamination leaves with it.
- Replace filters and clean the tank before refilling.
- Refill with the grade the equipment maker recommends, through a clean filter or transfer pump.
- Record the date and operating hours so the next change is planned, not forced.
Key takeaways
- Milky oil, a burnt smell, foam, pump noise and heat are early warnings.
- Oil analysis is more reliable than judging by colour.
- Fix the cause of contamination, or the new oil will fail the same way.